Kia Blind Spot Detection Not Working

When i shut the car off it went off.

Kia blind spot detection not working.

Remove the foreign matter on the rear bumper. Of course the blind spot alarm does not alarm if you don t signal for a lane change. If a failure code is displayed or a warning lamp turns on even after performing bsd radar correction 5 times replace the bsd unit. If the system does not work normally even though the foreign matter is removed take your vehicle to an authorized kia dealer and have the system checked.

If there is no problem mount the bumper back and perform bsd. If the system does not work properly a warning message will appear and the light on the switch will turn off. If you found any problem in the bsd unit bracket or nut tightening correct the problem or replace the component. When removing the bsd unit be careful not to damage the bracket of bsd.

And blind spot alarm is sure nice when backing out of parking spot if you are careless and not checking mirrors backup camera or looking. Service bulletin tsbele154 states that the blind spot collision warning malfunctions with a dtc c270254. Remove the foreign matter on the rear bumper. I m in northern california and was in fog mist by the coast at a standstill on the freeway due to an accident.

I find the main blind spot on the niro to be the front pillars especially on a left turn of say 90 degrees. I was driving to work and the warning light came on blind spot radar detector blocked. If the system does not work properly a warning message will appear and the light on the switch will turn off. Disconnect the bsd connector a from the bsd unit.

The bracket may break off from the bumper. They did however release another notice regarding other advanced safety systems which are just as important. Remove the bsd assembly a after loosening the mounting nuts. Be careful when removing the blind spot detection unit.

Once i got moving the light remained on until i got to work.